Key Features
- Pin-style cross-shaft design - works exclusively with original pin-style pedal hangers (will not fit bolt-style hangers with clip retention)
- Welded gusset reinforcement minimizes pedal flex and bending under heavy clutch loads
- Durable powder-coated black finish for corrosion resistance and clean underdash appearance
- Direct bolt-in replacement for original pinned-retention brake and clutch pedal sets
- Fits 1964-1966 Chevelle, El Camino, Pontiac GTO/Tempest/LeMans, Buick Special/Skylark, and Olds F-85/442
Description
Converting your '64-'66 GM A-body to a manual transmission - or replacing worn-out original pedals - means finding a clutch and brake pedal assembly that matches your car's specific hanger style. This pin-style pedal assembly is engineered for vehicles that originally came with pinned retention (not the bolt-style hanger with clip). Installing the wrong type means misalignment, binding, and potential safety issues. This assembly drops right in if your A-body uses the pin-style configuration.
The pedal arms feature a welded gusset that reinforces the structure where flex and fatigue typically occur. Under aggressive driving or with a high-effort clutch, factory pedals can develop play or even crack at stress points. The gusset transfers load across a broader area, keeping the pedal rigid and predictable through thousands of clutch cycles. The entire assembly is finished in a durable powder-coated black that resists corrosion, fluid contamination, and the general abuse of underdash life.
This assembly replaces both your brake and clutch pedals as a matched set, ensuring consistent pivot geometry and proper spacing. Whether you're doing a full manual transmission swap or restoring a numbers-matching four-speed car, this pedal set provides the foundation for reliable clutch actuation.
Fits 1964-1966 Chevrolet Chevelle, El Camino, and all GM A-body platforms including Pontiac GTO, Tempest, and LeMans; Buick Special and Skylark; and Oldsmobile F-85 and 442. Confirm your car uses pin-style retention before ordering - if your hanger uses a bolt with clip, see part number MD-402-2005-B instead.
Kit Includes
- Clutch and brake pedal assembly with pin-style cross-shaft
- Powder-coated black finish
- Welded gusset reinforcement
- Installation hardware [VERIFY: confirm specific hardware included - bushings, springs, retainer clips?]