Reverse Switch Wiring Harness | 1987-1993 Mustang | Manual Transmission
Key Features
- Direct replacement for Ford OE part number F1ZZ-14405
- Fits all 1987-1993 Mustang models with 5-speed manual transmission
- 14-inch harness length with factory-style connector
- Includes retainer clip to secure harness away from moving components
- Plug-and-play installation - no splicing or wire modification required
Description
Dead backup lights on your Fox Body? The factory reverse switch harness is often the culprit. After three decades of heat cycles, road spray, and transmission vibration, the original wiring becomes brittle and the connector corrodes - leaving you without functional reverse lights when you need them most.
This replacement harness restores reliable backup light operation with a factory-correct pigtail connector that plugs directly into the reverse switch on your T5 transmission. Built to match Ford's original F1ZZ-14405 specification, the 14-inch harness provides the correct length to route cleanly from the transmission to the vehicle's main wiring harness without excess slack or tension.
The included retainer clip secures the harness away from the driveshaft and other rotating components - a detail often overlooked with generic replacements that can lead to chafing and premature failure. Installation takes minutes: disconnect the old harness from the reverse switch, connect the new one, and secure with the retainer. No splicing, no wire stripping, no electrical tape required.
Compatible with all 1987-1993 Mustang variants equipped with manual transmission, including LX, GT, and SVT Cobra models.
Kit Includes
- Reverse switch wiring harness with factory-style 2-pin connector (14 inches)
- Harness retainer clip