Qwik Stik Shifter | T56 Windsor & S-10 T5 Square Base | 1" Left, .65" or 1.15" Forward
Key Features
- 1" left, .65" or 1.15" forward offset stub for precise shifter placement
- Close-ratio, short-throw design for lightning-quick shifts
- Small top turret clears tunnel shifter opening without cutting your floor
- Billet aluminum construction for weight savings and durability
- Belleville spring detent system - no stops to break or replace
- 7/8" on-center stub mounting fits most aftermarket shift levers
- High-temperature lower dust boot included
- Anodized finish for long-lasting corrosion resistance
- No stops design allows easy servicing when needed
Description
Swapping a T56 Windsor or S-10 T5 into your classic build? The factory shifter rarely lands where you need it. The MDL Qwik Stik solves the placement problem with a 1" left, .65 or 1.15" forward offset stub that positions your shift lever exactly where your hand naturally falls - no guesswork, no floor surgery.
These precision-machined and anodized plates mount directly to your transmission, taking all the worry and hassle out of shifter placement. The narrow shift body clears the shifter hole without cutting the floor - a critical advantage in restomod builds where preserving the factory floor opening matters. The close-ratio, short-throw geometry delivers lightning-quick response that transforms the driving experience compared to the stock shifter.
The Belleville washer detent system provides crisp, positive engagement through every gate - especially noticeable on quick 2-3 shifts. Unlike traditional stop-equipped shifters, the Belleville spring design means there are no stops to break or replace, and the shifter is easy to service when needed. The 7/8" on-center stub mounting accepts most aftermarket shift levers, so you can run your preferred handle and knob combination.
Fits square-base T56 Windsor (non-Magnum) 6-speed and S-10 style T5 5-speed transmissions. Proudly crafted with care in the USA.
Kit Includes
- Billet aluminum shifter assembly with anodized finish
- 1" left, .65" or 1.15" forward offset stub
- High-temperature lower dust boot
- Belleville washer detent system